How to clean your fan?

How to clean your fan? You may think that it is very difficult but it really isn’t that hard. The process is simple and you can easily learn the steps by reading this article.

If you already have a clean fan, before you start cleaning it, turn it on and run a cycle to start removing the dust and grime. Make sure the blade is disengaged first before you do any cleaning. It would be better if you use a soft cloth or a paper towel to wipe off the dust from the fan blade. Then, remove the blade guard.

You should be able to clean your fan via the four main points of the fan: the blower housing, the motor housing, the component slots and the filter. In cleaning the blower housing, you have to first identify which blower is dirty. For instance, it can be caused by dust or by hair that gets stuck into the holes. Remove the object and wipe it off. This will prevent your fan from working well so you have to make sure that everything is clean.

To clean the other parts of your fan, you have to first understand their role. The first thing to do is to remove any debris from the blade assembly. You can do this by either disassembling it or by pulling it apart. Afterwards, you have to remove any clamps, clips or other components that are connected to it. Once you have cleaned your fan, you can now clean the other parts of it.

How to clean your fan? When cleaning the filter, it is advisable to purchase a good quality HEPA filter that is also certified by the EPA. Remove the dirt from it by gently wiping it on the fan blades. In order to ensure that the filter remains in good condition, remove the gasket at the base of the unit. It is advisable to not use detergents on it because they can damage the plastic part of the filter.

How to clean your fan? On the other hand, when cleaning the blades, you have to remove any debris such as hair, dust or dander. Clean it using a soft cloth or cotton swab. Make sure that you never scrape the blade while cleaning it. After removing any kind of debris, dry it with a clean cloth before replacing it. Make sure that you remove all the gaskets attached to the blade.

How to clean your fan? The next step is to turn on your power to your motor and plug in. Start the motor by spinning it for several minutes. In order to eliminate any clogging in the filter, it is advisable to take place the filter in a pot that contains baking soda. After allowing the baking soda solution to sit for at least half an hour, it is advisable to clean the blade by replacing it in the old position.

How to clean your fan? You may also want to know how to clean your fan? While you are replacing the blades, make sure to follow the manufacturer’s instructions to the letter. Replace the fan back into the box and leave it alone to cool down for a few minutes before plugging it back into the wall.

How to clean your fan? While you are testing the blade, make sure to replace the blade properly. Begin the cleaning process by loosening all the screws on the blade. With the help of a screwdriver, pry out the old blade. Once the old blade is removed, insert the new blade and set it in the same spot.

How to clean your fan? Now, it is time to perform the actual cleaning process. Before you begin the cleaning process, ensure that the blade is totally free from any debris. For this purpose, it is advisable to run a vacuum over the entire surface to eliminate any air particles. When the blade is free of debris, you can then wipe it with a piece of clean cloth or a sponge.

How to clean your fan? Your fan is now ready to be used once again. However, before replacing the blades, make sure that you check and replace the bulb. This bulb is usually situated on the bottom side of the fan.